If your mission is to cut down a tree, know that you must use wisdom. Indeed, you need to be cautious when it comes to cutting down a tree. Moreover, you must seek efficiency in your work. That said, it is essential to use good techniques to achieve this. You need to be methodical and create a safe working environment. Thus, the tree that needs to be felled will be taken down without putting your life in danger. How to actually fell a tree safely? Discover all the good answers in the following lines.
Better equipped for better felling!
To successfully fell a tree and not waste time, you must choose sophisticated equipment. Furthermore, always keep in mind that felling a tree can be dangerous if you don’t know how to go about it. The equipment that will allow you to succeed in your mission without panic and safely is the chainsaw. Here again, you should not choose just any chainsaw. You will inevitably take into account the volume. Its power must also allow it to fell the tree you have in front of you. So, take a look at tronconneuse.xyz and you will find the suitable model. Felling a tree with a powerful chainsaw will take you between 1 hour and 4 hours.
A découvrir également : How to Beautify Your Garden with Ease?
Choosing the direction of the tree’s fall
The very first thing to check is that the tree does not fall in your direction during its fall. It is therefore important to carefully check its direction of fall. You can take into account the direction of the wind to know where the tree will fall. After that, you need to clear the area around its fall zone and set up warning signs so that people pay attention. You should also create an escape route by clearing a path at a 45° angle behind your tree in both directions. Once the direction is known, you will remove all branches from the tree trunk to see it better. Here, you can use a pulling chain from top to bottom. For your safety as well, you need to check if the tree is healthy. Indeed, if the tree is rotten or shows signs of decay, know that it is not sturdy and proceed with caution during felling.
A good technique for safe felling
Once the side of the tree’s fall is identified, you will begin to cut your tree. This will be done to a depth of 1/3 to a quarter of the diameter of the tree trunk. This is the same trunk that has just been pruned. The cutting will be done from top to bottom with a minimum 45° angled cut. You will now make a horizontal notch to reach the base to finally remove the formed wood wedge. Then, you will make a felling cut on the opposite side of the notch. Here, the hinge will have the same thickness, and you need to insert the felling lever before the tree pinches your guide bar.
A lire également : How to Use a Sitemap to Optimize Navigation on Your Gardening Site
For more precision, this cut should be 3 cm higher than the second cut of your notch. However, the two should not meet. As you progress in this manner, you will see that the tree will begin to tilt toward its fall side. It is then time to retreat so that the tree can fall. Once the tree is on the ground, you can proceed to limbing.